User`s manual

T-5
T
V. The debugger
is in system
mode and the
board auto
boots, or the
board has passed
selftests.
A. No problems -
troubleshooting
is done.
No further troubleshooting steps are required.
Note
Even if the board passes all tests, it may
still be bad. Selftest does not try out all
functions in the board (for example, SCSI,
or VMEbus tests).
VI. The board
has failed one or
more of the tests
listed above, and
can not be
corrected using
the steps given.
A. There may be
some fault in the
board hardware
or the on-board
debugging and
diagnostic
firmware.
1. Document the problem and return the board for
service.
2. Phone [phone].
YOU ARE FINISHED (DONE) WITH THIS TROUBLESHOOTING PROCEDURE.
Table T-2. Troubleshooting MVME147 Series Boards Only (Continued)
Condition Possible Problem Try This: