Personal Computer User Manual

Hardware Preparation and Installation
2-6 Installation Guide
2
Configuration Switch S6: Serial Port 4 Clock Select (S6-1, S6-2)
Serial port 4 can be configured to use clock signals provided by the RTXC4 and
TRXC4 signal lines. Switch segments S6-1 and S6-2 on the MVME197LE
configures serial port 4 to drive or receive TRXC4 and RTXC4, respectively.
Factory configuration is with serial port 4 set to receive both signals (open).
The remaining configuration of the clock lines is accomplished by using the
Serial Port 4 Clock Configuration Select header on the MVME712M transition
module. Refer to the MVME712M Transition Module and P2 Adapter Board
User’s Manual for configuration of that header.
Installation Instructions
The following sections discuss installation of the MVME197LE into a VME
chassis, and system considerations. Ensure that BOOT ROM device is
installed. Ensure that all switches are configured as desired.
Switch S6
Receive TRXC4 Receive RTXC4
(FACTORY CONFIGURATION)
Switch S6
Drive TRXC4 Drive RTXCC4
1 2
1 2
O
N
O
N
CLOSED
OPEN
CLOSED
OPEN