Personal Computer User Manual

MVME197LEIG/D1A-1
A
CONFIGURE AND
ENVIRONMENT COMMANDS
Configure Board Information Block
CNFG [;[M][I]]
This command is used to display and configure the board information block.
This block is resident within the Non-Volatile RAM (NVRAM). Refer to the
MVME197LE Single Board Computer User’s Manual for the actual location. The
board information block contains various elements detailing specific
operation parameters of the hardware. The MVME197LE Single Board
Computer User’s Manual also describes the elements within the board
information block, and lists the size and logical offset of each element. The
CNFG command does not describe the elements and their use. The board
information block contents are checksummed for validation purposes. This
checksum is the last element of the block.
Example: To display the current contents of the board information block.
Note that the parameters that are quoted are left-justified character (ASCII)
strings padded with space characters, and the quotes (“) are displayed to
indicate the size of the string. Parameters that are not quoted are considered
data strings, and data strings are right-justified. The data strings are padded
with zeros if the length is not met.
In the event of corruption of the board information block, the command
displays a question mark “?” for nondisplayable characters. A warning
message
(WARNING: Board Information Block Checksum Error) is also
displayed in the event of a checksum failure.
Using the | option initializes the unused area of the board information block to
zero.
197-Bug>cnfg
Board (PWB) Serial Number = "0000000xxxxx"
Board Identifier = "MVME197LE "
Artwork (PWA) Identifier = "01-W3869B01A "
MPU Clock Speed = "5000"
Ethernet Address = 08003E21EG7A
Local SCSI Identifier = "07"
197-Bug>