Technical data

Index
IN-2 Computer Group Literature Center Web Site
I
N
D
E
X
configuring
177Bug parameters 3-10
hardware 2-5
VMEbus interface 3-14
connector pin assignments 5-1
connectors 4-14
console port 2-6
control/status registers 1-14
controller LUN (CLUN) C-1, D-1
controller modules (disk/tape) D-1
controller modules (network) C-1
cooling requirements A-2
D
data bus structure 4-4
data sheets E-2
date and time, setting 2-7, B-2
debugger
commands 3-5
firmware (177Bug) 3-8
prompt 3-4
decimal number, symbol for xvii
default baud rate 2-7
device LUN (DLUN) C-1, D-2
diagnostic facilities 2-13
dimensions, base board A-1
direct access devices D-4
directories, switching 2-13
disk/tape controller modules supported D-1
DLUN (device LUN) C-1, D-2
DMA functionality 4-10
DRAM (dynamic RAM)
base address 1-14
options 4-6
E
ECC DRAM emulations 1-10
EIA-232-D ports 2-6
ENV command parameters 3-10
environmental parameters 3-8
EPROM and Flash memory 4-6
EPROM socket 4-6
EPROM/Flash mode (S4) 1-10, 2-6
EPROMs 3-3
ESD (electrostatic discharge), precautions
against 1-3
ESDI Winchester hard drive D-3
Ethernet
controller modules supported C-1
interface 4-11
station address 4-11
extended addressing 1-13
F
features, hardware 4-1
firmware 2-2
firmware directories 3-4
Flash memory 4-6
flexible diskettes (controller data) D-2
floppy diskettes D-4
floppy drives (disk/tape controller) D-2, D-3
forced air cooling A-2
functional description 4-1
G
GCSR (global control/status registers) 1-14
general information 1-1
general-purpose readable header J1 1-5, 2-5
global bus timeout 1-14
global control/status registers (GCSR) 1-14
grounding strap, use of 1-3
H
handshaking, hardware 2-7
hard disk drive D-3
hardware
features 4-1
initialization 2-3
interrupts 4-13
preparation 1-3
hexadecimal number, symbol for xvii
humidity, relative A-1