Technical data

Index
IN-4 Computer Group Literature Center Web Site
I
N
D
E
X
parallel printer port 4-10
parameters, ENV command 3-10
PCCchip2 ASIC
control of BBRAM and clock 4-8
LAN coprocessor support 4-11
SCSI controller support 4-12
Petra SDRAM size switch (S3) 1-9, 2-6
pin assignments, connector 5-1
port number(s), debugger command 3-5
power requirements A-1
powering up the board 2-1
printer interface 4-10
printer port 4-10
processor location monitors 1-14
programmable tick timers 4-12
Q
QIC-02 streaming tape drive D-4
R
related specifications E-3
relative humidity A-1
remote control/status connector (J3) 4-14,
5-2
RESET switch 4-14
resetting the system 2-1, 2-11
RF emissions, minimizing 1-12
ROMboot process 2-9
RTXC4 (Receive Transmit Clock 4) 1-8
S
SCC (serial communications controller) 2-7
SCSI
common command set (CCS) devices
D-2, D-4
controller (53C710) 4-11
direct access devices D-2
interface 4-12
sequential access devices D-2
termination 4-12
terminator configuration 4-12
terminator power 1-14
SD command 2-13
SDRAM (synchronous DRAM)
options 4-6
sequential access devices D-4
serial
communication parameters 2-4
communications controller (SCC) 2-7
port 4 clock configuration (J10/J11) 1-8,
2-6
port interface 4-9
ports 2-6
Set Bug/Operating System Environment
(ENV) firmware command 3-10
setting date and time 2-7, B-2
size of base board A-1
slave address decoders, VMEbus 3-14
software-programmable hardware interrupts
4-13
specifications
MVME177P A-1
related E-3
SRAM (static RAM) 4-6
backup power 2-5
backup power selection (J9) 1-7
startup and operation 2-1
startup problems, solving B-1
static RAM (SRAM) 4-7
static variable space (firmware) 3-4
storage temperature A-1
streaming tape drive D-4
switching directories 2-13
system console setup 2-6
system controller function 1-7, 2-5
system controller selection (J6) 1-7
System Fail (SYSFAIL*) signal, resetting
2-9
system reset 2-11
system startup 2-3