User`s manual

.NETCFIG
5-38
5
Boot File
Execution Delay
The delay, in seconds, before control is passed to
the loaded Þle (program).
Boot File Length The number of bytes from the data transfer
address to transfer. A length of 0 speciÞes to
transfer the entire Þle on a read. On a write the
length must be set to the number of bytes to
transfer.
Boot File Offset The offset into the Þle on a read. This permits users
to wind into a Þle.
BOOTP/RARP
Request Retry
The number of the number of retries that should be
attempted prior to giving up. A retry value of zero
speciÞes always to retry (not give up).
TFTP/ARP
Request Retry
The number of retries that should be attempted
prior to giving up. A retry value of zero speciÞes
always to retry (not give up).
Trace Character
Buffer Address
The starting address of memory in which to place
the trace characters. The receive/transmit packet
tracing is disabled by default (value of 0). Any non-
zero value enables tracing.
Tracing would only be used in a debug
environment and normally should be disabled.
Care should be exercised when enabling this
feature; you should ensure adequate memory
exists. The following characters are deÞned for
tracing:
? Unknown
& Unsupported Ethernet type
* Unsupported IP type
% Unsupported UDP type
$ Unsupported BOOTP type
[ BOOTP request
] BOOTP reply
+ Unsupported ARP type
( ARP request