Routers Administrator's Handbook

133
SHELL Commands
Common Commands
arp nnn.nnn.nnn.nnn
Sends an Address Resolution Protocol (ARP) request to match the nnn.nnn.nnn.nnn IP address to
an Ethernet hardware address.
clear [yes]
Clears the configuration settings in a Motorola Netopia® Gateway. If you do not use the optional yes
qualifier, you are prompted to confirm the clear command.
clear_certificate
Removes an SSL certificate that has been installed.
clear_log
Erases the log information stored in flash if persistent logging is enabled.
configure
Puts the command line interface into Configure mode, which lets you configure your Motorola Netopia®
Gateway with Config commands. Config commands are described starting on page 130.
diagnose
Runs a diagnostic utility to conduct a series of internal checks and loopback tests to verify network con-
nectivity over each interface on your Motorola Netopia® Gateway. The console displays the results of
each test as the diagnostic utility runs. If one test is dependent on another, the diagnostic utility
indents its entry in the console window. For example, the diagnostic utility indents the Check IP connect
to Ethernet (LAN) entry, since that test will not run if the Check Ethernet LAN Connect test fails.
Each test generates one of the following result codes:
download [ server_address ] [ filename ] [confirm]
This command installs a file of configuration parameters into the Motorola Netopia
®
Gateway from a
TFTP (Trivial File Transfer Protocol) server. The TFTP server must be accessible on your Ethernet net-
work.
CODE Description
PASS The test was successful.
FAIL The test was unsuccessful.
SKIPPED The test was skipped because a test on which it depended failed, or
because the test did not apply to your particular setup or model.
PENDING The test timed out without producing a result. Try running the test again.