Operation Manual
39Registration
10. Registration
Up to 11 handsets can be registered to one base station. Additional handsets must be
registered to the base before you can use them.
• The instructions described below apply specically to the handset of this model If you
wish to register another manufacturer’s handset, the instructions may vary. In this case,
please refer to the instruction manual of the additional handset.
• The System PIN is required to register or de-register handsets. The default PIN is 0000.
10.1 To register a handset
On the base:
1. Press and hold
p until the base emits a double beep. The base will remain in
registration mode for 90 seconds.
On the handset:
1. If the handset is new, the display shows
Please register
. Press
Reg
.
2. Display shows
Press and Hold Base Find Key
.
3. Press
OK
, display shows
Searching Base X
. If the system PIN is 0000 (default) the
handset will automatically register, if the PIN has been changed enter the system PIN
and press
OK
.
4. When registration is complete, the display shows
Handset Registered
.
Or
If the handset has already been registered to another base, the standby display is
shown. Press
Menu
, scroll D to
Registration
and press
Select
.
5.
Register HS
is highlighted. Press
Select
.
6. Bases are displayed. If necessary, scroll
U or D to a new base you wish to register the
O2 handset to and press
Select
.
7. If you are replacing a base that is already indicating
In Use,
when you press
Select
the
display shows
Replace Base X?
Press
Yes.
8. The display shows
Searching Base X
. If the system PIN is 0000 (default) the handset will
automatically register, if the PIN has been changed, enter the system PIN and press
OK
.
NOTE
If registration is not successful the rst time, please repeat the process again in case the
base registration period ran out of time.
If there are already 11 handsets registered to the base, registration will fail. You must de-
register a handset before you can register a new one.