user manual

3-12 Computer Group Literature Center Web Site
PPCBug Firmware
3
Auto Boot at powerup only [Y/N] = N?
Auto Boot Scan Enable [Y/N] = Y?
Auto Boot Scan Device Type List = FDISK/CDROM/TAPE/HDISK?
This is the listing of boot devices displayed if the Autoboot Scan option is
enabled. If you modify the list, follow the format shown above (uppercase
letters, using forward slash as separator).
Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing of
disk/tape controller modules currently supported by PPCBug. (Default =
0x00)
Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual listed in
Appendix C, Related Documentation for a listing of disk/tape devices
currently supported by PPCBug. (Default = 0x00)
Auto Boot Partition Number = 00?
Identifies which disk “partition” is to be booted, as specified in the
PowerPC Reference Platform (PReP) specification. If set to zero, the
firmware will search the partitions in order (1, 2, 3, 4) until it finds the first
“bootable” partition. That is then the partition that will be booted. Other
acceptable values are 1, 2, 3, or 4. In these four cases, the partition
specified will be booted without searching.
Y Autoboot is attempted at powerup reset only.
N Autoboot is attempted at any reset. (Default)
Y If Autoboot is enabled, the Autoboot process attempts
to boot from devices specified in the scan list (for
example,
FDISK/CDROM/TAPE/HDISK). (Default)
N If Autoboot is enabled, the Autoboot process uses the
Controller LUN and Device LUN to boot.