Service manual

99R85452E01-O August 30, 2002
Maintenance
: Radio Disassembly — Detailed 2-7
2.6.2 Control Board Disassembly
1. Remove the screws which hold the control board to the RF board.
2. Remove the control board which is connected to the RF board through a board-to-board
connector (
See Figure 2-5.
).
2.6.3 RF Board Disassembly
1. Remove the screws and the stud which hold the RF board to the rear diecast with the Phillips
head screwdriver and socket wrench respectively.
2. Gently remove the RF board from rear diecast. The completely disassembled radio is shown
in
Figure 2-6
.
NOTE: The Control and RF boards are mounted with cross recess screws meeting the Phillips Cross
Slot number 1 standard. Using a Phillips 0 will damage the screw recesses as will a poorly
fitting Phillips 1 screwdriver. One example of a correct fitting screwdriver is manufactured by
PB Baumann (http://www.pbtools.ch/index_e.html) and is available from many electronic tool
dealers. The PB Baumann item number is 121/1-70. Other high quality manufacturer's
pruducts meeting the Phillips 1 standard are also acceptable.
Figure 2-5.
Figure 2-6.
Board-to-board
connector