Service manual

August 30, 2002 99R85452E01-O
2-8
Maintenance
: Radio Reassembly — Detailed
2.7 Radio Reassembly — Detailed
2.7.1 RF Board Reassembly
1. Place the RF board on the rear diecast.
2. Tighten the screws and the stud.
2.7.2 Control Board Reassembly
1. Place the control board on the RF board.
2. Connect the control board to the RF board by pressing it firmly downwards at the board-to-
board connector (
See Figure 2-7.
).
3. Tighten the screws using a screwdriver to hold the control board in place.
2.7.3 Chassis and Front Cover Reassembly
1. Remove the metal retainer with a small flat head screwdriver (
See Figure 2-11.
).
Figure 2-7.
Figure 2-8.
Board-to-board
Connector
Housing tab
Retainer