Service manual

99R85452E01-O August 30, 2002
Radio Programming
: Programming 4-5
4. Press + again. Enter 036, when 2-02- appears, and subsequently in this manner, enter the
other channels.
NOTE: If a mistake is made, use + or - to move to the appropriate scan list member holder and press
# to erase the channel number.
5. Press PTT or MON, when all the channel numbers have been entered.
6. Turn off your radio, if you have completed the programming, or proceed to the next
parameter.
4.4.3.2 Programming a Phone Number/Access Code/De-Access Code
Scenario: To program the phone number, 9-72886338 (where “-” represents a Pause digit), at
memory location 8.
Steps:
1. Enter Programming Mode, by pressing MON and turning on the radio.
2. Press PTT or MON until TELNO-8 is displayed.
3. Press +. The cursor will be placed on the first character.
4. Use the keypad to enter 9.
5. Enter a Pause digit, by entering * followed by #. These two characters will be converted into a
Pause, represented by ‘-’.
NOTE: Each Pause digit entered shortens the overall length of the code/number by a digit.
6. Use the keypad to enter the rest of the phone number.
NOTE: If a mistake is made, use + or - to move to the appropriate location and then re-enter the
correct character. To erase the complete phone number/code, enter # 16 times.
7. Press PTT or MON, when the complete phone number has been entered.
8. Turn off your radio, if you have completed the programming, or proceed to the next
parameter.