User's Manual

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)

1 Preparation and Installation

Figure 1-2. Installing a PrPMC800/800ET on a VMEmodule

5. Align the standoffs on the PrPMC800/800ET mezzanine with the VMEmodule or

CompactPCI board. Install the Phillips-head screws through the holes in the baseboard

and the spacers. Tighten the screws.

6. Install the VME or CompactPCI assembly in its proper card slot. Ensure the module is

seated properly in the backplane connectors. Do not damage or bend connector pins.

7. Replace the chassis or system cover(s) and connect the system to the AC or DC power

source. Turn the equipment power on.