User guide

112
Once the Overall Update Progress bar has reached 100%, proceed to the next step.
Figure 55 - Software Upgrade Complete
When the software image has been written to memory
Figure 55 will be displayed showing
the status of the software upload.
Reboot the unit by clicking the “Reboot Wireless Unit” button. This will reboot the unit within
30 seconds, and during this time you will not be able to communicate with the unit. The unit is
now fully functional.
If this screen is not displayed after 60 seconds it could indicate a problem with the memory
update process.
The user should now power cycle the unit to start using the new software image. The unit’s
boot software will automatically determine the health of the newly uploaded software image. If
any problems were encountered the boot code will revert to a protected fixed software image
After the power cycle the user should check that the required software image is loaded and
running by re-entering the Upgrade page where the software bank status will be displayed.