Operation Manual

ManualsBrandsMotorola ManualsUniversal RemoteR331

R331 Rechargeable Remote Control

1. How to connect the Base Station

STEP 1. Determine where you would like to place the Base Station.

STEP 2A - Powering from your Set-top (within 3 feet). Connect the “square” end of the

supplied USB cable to the Base Station and the “rectangle” end to the back of the Set-top.

STEP 2B - Powering from a Wall Outlet (further than 3 feet from Set-top). Connect one

end of the supplied plug-in power supply to the Base Station and the other end to a near

by wall socket.

Note: you only need to follow STEP 2A, or STEP 2B, not both.

2. How to set the clock

STEP 1. Use the +H and the +M buttons on the bottom of the Base Station to set the

hours and minutes of the clock.

STEP 2. With the remote control in the Base Station, press and hold the FIND button

which will cause the clock to dim as desired. Press and hold the FIND button again to

make clock brighter as desired.

3. How to charge the remote control

STEP 1. Place the remote control in the Base Station. A magnet inside the Base Station

pulls the remote into place to make contact with the charging pins.

STEP 2. Make sure that the charging points are in full contact by seeing that the charging

lights on the Base Station are lit.

NOTE: It is not necessary to charge the remote control often, but remember to place it in

the Base Station for at least two overnight sessions per month if possible. Quick charge

the remote in 30 minutes or fully charge the remote in 12 hours.

4. How to manually setup the remote

STEP 1. Power on the device you want to setup.

STEP 2. Locate the 4-digit code from the code list (see pages 29 and 30).

STEP 3. Press and hold the mode key (TV, DVD, or AUX) and while holding the mode

key, press the OK key.

STEP 4. Release both the mode key and the OK key. All the mode keys flash but the

selected mode key stays on.

STEP 5. Enter the 4-digit code from the code list. The selected mode key light blinks for

each digit entry and remains off after the entry of the fourth digit.

STEP 6. Point the remote control at the selected device and press the power key once.

The device should turn off if you have found the correct 4-digit code.

STEP 7. If there are multiple codes and one does not work, repeat steps 2-6 using the

next code until you find the correct one. If it still does not work as intended, please refer to

the advanced section starting on page 9.

Write your codes here so you don’t forget them.

TV________ DVD________ AUX________

Summary of content (8 pages)

PAGE 1
R331 Rechargeable Remote Control 1. How to connect the Base Station STEP 1. Determine where you would like to place the Base Station. STEP 2A - Powering from your Set-top (within 3 feet). Connect the “square” end of the supplied USB cable to the Base Station and the “rectangle” end to the back of the Set-top. STEP 2B - Powering from a Wall Outlet (further than 3 feet from Set-top). Connect one end of the supplied plug-in power supply to the Base Station and the other end to a near by wall socket.
PAGE 2
R331 Rechargeable Remote Control 5. How to use the Find Feature STEP 1. If you have misplaced the remote control, simply press the button labeled FIND on the Base Station. The remote will sound and flash to make it easy to find your misplaced remote control. STEP 2. Once you have located the remote control, press any key on the remote to stop the sound and flashing keys. 6. Manual Programming Use the following steps to setup the TV, DVD or AUX mode keys: 1.
PAGE 3
R331 Rechargeable Remote Control 8. Learning Commands 1. Press and hold the mode key (TV, DVD, or AUX) on the Motorola remote and while holding it pressed, press the LEARN key for one second then release both keys. 2. All of the mode keys will flash and then the selected mode key light remains on. 3. On your Motorola remote, press and release the key that you want to teach. 4.
PAGE 4
R331 Rechargeable Remote Control 10. Volume Control Setup Options The volume controls will control your Set-top until the TV device mode is programmed, e.g. if DVD mode is selected then volume controls your Set-top.. If TV mode is programmed and DVD mode is selected, then volume controls your TV. If you'd like the volume commands to operate from just one device, e.g. always TV, then follow the instructions in Section E-I.
PAGE 5
R331 Rechargeable Remote Control 11. Channel Control Setup Options The channel controls (Channel Up/Down, 0-9 and LAST) will always work your Set-top. If you'd like the channel commands to be sent to different devices depending which mode you are in. A. Channel Control Depends on Device Selected 1. Press and hold the TV key and while holding it pressed, press the OK key for one second. 2. Release both keys, all of the mode keys flash followed by the TV mode key light remaining on. 3.
PAGE 6
R331 Rechargeable Remote Control 13. Multiple Device Power Control Setup Options After pressing the STB key, pressing the Power key turns the Set-top on or off, AND turns on or off the TV if it has been setup. If you want the Power key to turn on other devices at the same time you can enable these as follows: 1. Press and hold the STB key and while holding it pressed, press the OK key for 1 second. Then release both keys. You are now in setup mode. 2.
PAGE 7
R331 Rechargeable Remote Control 16. Finding More Than One Remote If you own more than one Motorola TV Easy Find Remote Control and Base Station, you can set each Base Station to find only its own remote with 16 unique codes. With the first power up of the Base Station, it will be set to find ALL remotes. To set the Base Station so that it finds a specific remote when there are multiple remote in the household, follow the instructions on the following page: 1.
PAGE 8
R331 Rechargeable Remote Control i. End the learn session by pressing the LEARN key. ii. Clear out the learned commands for that mode. iii. Check the IR elements are correctly aligned between the two remotes. iv. Adjust the distance between the two remotes to be closer (e.g. half an inch) or further away (e.g. 2 inches) from each other. v. Try learning the original remote for that mode again.