Operation Manual

R331 Rechargeable Remote Control
i. End the learn session by pressing the LEARN key.
ii. Clear out the learned commands for that mode.
iii. Check the IR elements are correctly aligned between the two remotes.
iv. Adjust the distance between the two remotes to be closer (e.g. half an inch) or
further away (e.g. 2 inches) from each other.
v. Try learning the original remote for that mode again. If problems reoccur with the
same key check the original remote key being learned – does it transmit? Does it
operate the target device? Try learning that key under a different clear mode. If it
learns OK then it is likely to be a different code type from the others and cannot be
learned under the same mode.