Owners Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Canada Licensing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Side Buttons
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Attaching the Antenna
- Removing the Antenna
- Installing Spring Action Belt clip.
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Drop-in Tray Charger LED Indicators
- Estimated Charging Time
- Multi-Unit Charger LED Indicators
- Getting Started
- Turning radio ON/OFF
- Adjusting Volume
- READING THE DISPLAY
- Selecting a Channel
- Talking and Monitoring
- Receiving a Call
- Signal strength indicator and channel busy indicators
- Talk Range
- Radio LED Indicators
- Hands-Free Use/VOX
- Toggle Voice Prompt in User Mode
- Power Up - Tone Mode
- Reset to Factory Defaults
- Keypad Beeps
- Keypad Lock/Unlock
- Menu Options
- Setting VOX/IVOX Sensitivity
- Microphone Gain
- Programming Features
- Advanced Configuration Mode
- Programming RX (Reception) Frequencies
- Programming RX (Reception) codes (CTCSS/DPL)
- Programming Scramble
- Programming Maximum Number of Channels
- Programming Call Tones
- Programming Microphone Gain Level
- Programming Microphone Accessory Gain Level
- Other Programming Features
- Customer Programming Software (CPS)
- Text-to-Speech (Changing Pre- Defined Voice Aliases)
- Weather Feature (Not for RDU4163)
- The Weather Alert has two modes of operations
- Event Type Filter
- Warning
- Watch
- Emergency
- Statement
- Event Code Filter
- Block Event
- Event Code
- The Critical Events Table
- Geographic Filter
- State
- County
- FIPS
- Cloning Radios
- Troubleshooting
- Use and Care
- Frequency and Code Charts
- Accessories
- Motorola Solutions Limited Warranty for the United States and Canada
English
42
PROGRAMMING FEATURES
The radio display shows the Scan Programming Mode
as follows:
Both the channel number and current scan setting
(YES = Enable or NO = Disable) blinks on the display,
indicating you can choose your setting. To set the
channel number, rotate the Channel Selector Knob
until you reach the desired channel number.
Once you have selected the channel, proceed to
enable (‘YES’) or disable (‘NO’) the scan feature by
pressing the SB2 (*) button. Once you have set the
values you need, long press the PTT button to exit
and save, or short press the PTT button to move to
the next programming feature without saving.
Note:
• (*) This assumes the SB2 button is not
programmed for a different mode.
• If the Maximum Channel setting in the radio is
set to ‘1’, the Scan Programming option is
disabled and will not show on the radio display.
Programming Weather Channel (Not
allowed on RDX4163)
Weather Channel Programming Mode is the last
programming mode available. You can enable or
disable the Weather Channel.
To do so, enter the Advanced Configuration Mode and
select the channel you want to program. Scroll
through the programming modes by short pressing
the PTT button or (Menu) button until you reach the
‘Weather Channel Programming Mode’.
Press the Programmable Button A and Programmable
Button B buttons to enable or disable the mode. Refer
to “Weather Channel Frequencies Table” on page 47
for the frequency table.
Editing Channel Alias Name
To edit a Channel Alias Name, turn ON the radio and
press and hold the PTT button simultaneously with the
button for 3 seconds. The radio generate a special
beep upon entering the ‘Channel Alias Mode’.
MN002894A01_final.book Page 42 Wednesday, January 4, 2017 5:32 PM