Use and Care Manual

English

GETTING STARTED

Hands Free without Accessories (iVOX)

• Enable iVOX by pressing the PTT Button while

turning ON the radio.

• A short press of the PTT Button re-enables iVOX.

• There is a short delay between the time when you

start talking and when the radio transmits.

SETTING VOX/IVOX SENSITIVITY

The sensitivity of the radio's accessory or microphone

can be adjusted to suit different operating

environments. VOX sensitivity can be programmed

via the CPS.

Default value is OFF. If you want to use the VOX

feature, VOX level should be set at a different level.

• 1 = High audio input level will trigger the Tx

• 2 = Medium sensitivity

• 3 = Low audio input level will trigger the Tx

TOGGLE VOICE PROMPT IN USER MODE

Short press the SB1 Button while turning ON the radio

to enable/disable the Voice Prompt in User Mode.

(Default is set to ON).

POWER UP - TONE MODE

To enable/disable power up tone mode, press SB1

and SB2 buttons simultaneously for 2-3 seconds while

powering up the radio until you hear the pre-

programmed power up tone. Three different power-up

tones are available.

RESET TO FACTORY DEFAULTS

Reset to Factory Defaults will set back all radio

features to the original factory default settings. To do

so, press PTT, SB2 and SB1 simultaneously while

turning ON the radio until you hear a high tone chirp.

MICROPHONE GAIN

The sensitivity of the microphone can be adjusted to

fit different users or operating environments.

This feature can be adjusted only through the CPS.

Microphone default setting is set to level 2 (medium

gain).

MN002895A01_final.book Page 34 Thursday, January 5, 2017 10:51 AM