Installation guide

Hardware Setup
15
4.3 Connecting USB Devices
The RFS6010 RF Switch contains one USB port for connecting USB flash storage devices to the
switch. The switch can use the USB flash storage device for file and log transfers. Follow the setup
instructions below to connect the devices to the switch and then access those devices through the
Web UI or Command Line Interface.
1. Connect the USB flash drive to the USB .
2. Wait a few seconds for the drive to be recognized by the switch.
3. Follow the instructions in the Motorola RF Switch System Reference or CLI Reference for more
information on accessing USB storage devices from the switch for file transfers or firmware
updates.
NOTE The switch supports USB flash devices formatted with FAT or VFAT
(FAT32) filesystems only. If your flash storage device is formatted with
another filesystem you will need to format
USB
port