Installation guide

Overview
1-2
Access ports do not have software or firmware upon initial receipt from the factory. When the access port is
first powered on and cleared for the network, the switch initializes the access port and installs a small
firmware file automatically. Installation and firmware upgrades are automatic and transparent.
1.1.1 Physical Specifications
The physical dimensions and operating parameters of the switch include:
1.1.1.1 Power Cord Specifications
A power cord is not supplied. Use only a correctly rated power cord certified for the country of operation.
1.1.1.2 Power Protection
To best protect the switch from unexpected power surges or other power-related problems, ensure the system
installation meets the following power protection guidelines:
• If possible, use a dedicated circuit to protect data processing equipment. Commercial electrical
contractors are familiar with wiring for data processing equipment and can help with the load
balancing of dedicated circuits.
• Install surge protection. Use a surge protection device between the electricity source and the switch.
• Install an Uninterruptible Power Supply (UPS). A UPS provides continuous power during a power
outage. Some UPS devices have integral surge protection. UPS equipment requires periodic
maintenance to ensure reliability. A UPS of the proper capacity for the data processing equipment
must be purchased.
Width 440mm (17.32 in)
Height 44.45mm (1.75 in)
Depth 390.8mm (15.38 in)
Weight 6.12 Kg (13.5 lbs)
Operating Temperature 0°C - 40°C
Operating Humidity 5% - 85% RH, non-condensing
Operating Altitude 3 km (10,000 ft.)