Personal Computer User Manual

RAM500 Module Installation

D-6 Computer Group Literature Center Web Site

that standoffs are installed in the three mounting holes on the

module.

5. With standoffs installed in the three mounting holes on the

RAM500 module, align the standoffs and the P1 connector on the

module with the three holes and the J16 connector on the

MVME5100 host board and press the two connectors together until

they are firmly seated in place.

Figure D-2. RAM500 Module Placement on MVME5100

6. (Optional step) If a second RAM500 module is being used, align the

top connector on the bottom RAM500 module with the bottom

connector on the top RAM500 module and press the two connectors

together until the connectors are seated in place.

7. Insert the three short Phillips screws through the holes at the corners

of the RAM500 and screw them into the standoffs.