Personal Computer User Manual

http://www.motorola.com/computer/literature IN-3
I
N
D
E
X
I
I/O modes
described (PMC and SBC) 4-3
IACK and BG signals 1-17
IDSEL routing 4-9
initialization
performed by PPCBug 2-4
initialization process
as performed by firmware 3-4
Input/Output Interface 4-7
installation
RAM500 D-5
installation considerations 1-5
installing
multiple MVME510x boards 1-7
MVME510x 1-16
MVME510x hardware 1-8
MVME510x into chassis 1-16
PCI mezzanine cards 1-10
PMCs 1-10
PMCspan 1-12, 1-14
primary PMCspan 1-12
secondary PMCspan 1-14
Internal Clock Frequency 4-1
interrupt
from ABORT switch 2-1
interrupt architecture, MVME510x 6-10
Interrupt Controller 4-2
interrupt routing 4-8
interrupt signals 2-1
interrupt support 6-9
IPMC761
pin assignments (J3) 5-3
IPMC761 Interface 5-1
ISA bus 2-1, 6-6, 6-9
J
jumper headers 1-4
jumper settings
MVME5100 5-2
jumpers and connectors 5-1
jumpers, backplane 1-17
junction temperature
measuring E-6
L
L2 Cache 4-2
L2 Cache Parity Enable 3-16
LED/serial startup diagnostic codes 3-16
LEDs (light-emitting diodes), MVME510x
2-1
local air temperature
measuring E-9
lowercase 3-27
M
Main Memory 4-2
Memory 4-5
memory
Flash and SDRAM 4-5
RAM500 D-1
Memory Controller 4-2
Memory Expansion 5-1
memory map
CHRP 6-3
PCI local bus 6-2, 6-5
processor (default) 6-2
memory maps
MVME510x 6-1
VMEbus 6-6
memory size 3-15
Memory Size Enable 3-15
Miscellaneous 4-2
MPU initialization 3-3
mvme5100
description 1-1
MVME510x
installing 1-16
programming 6-1
N
Negate VMEbus SYSFAIL* Always 3-10
NETboot enable 3-14
Network Auto Boot Controller 3-14