Personal Computer User Manual

Index
IN-4 Computer Group Literature Center Web Site
I
N
D
E
X
Network Auto Boot enable 3-14
NIOT debugger command
using 3-15
Non-Volatile RAM (NVRAM) 3-7
non-volatile static RAM 4-8
NVRAM 4-2
NVRAM Bootlist 3-11
O
operation
parameter (Auto Boot Abort Delay) 3-13
parameter (Auto Boot Controller) 3-12
parameter (Auto Boot Default String)
3-13
parameter (Auto Boot Device) 3-12
parameter (Auto Boot Partition Number)
3-12
parameter (L2 Cache Parity Enable)
3-16
parameter (Memory Size) 3-15
parameter (Negate VMEbus SYSFAIL*
Always) 3-10
parameter (Network Auto Boot Control-
ler) 3-14
parameter (NVRAM Bootlist) 3-11
parameter (Primary SCSI Bus Negotia-
tions) 3-10
parameter (Primary SCSI Data Bus
Width) 3-11
parameter (ROM Boot Enable) 3-13
parameter (SCSI bus reset on debugger
startup) 3-10
parameter (Secondary SCSI identifier)
3-11
Operation Mode Jumpers 5-1
P
P1 and P2 1-6
P2 Input/Output (I/O) Mod 4-7
Pal Programming Header 5-1
parallel port 6-11
parity 2-3
PC100 ECC 4-2
PC16550 2-3
PCI bus 6-5, 6-9
PCI Expansion Connector 4-2
PCI Expansion Interface 5-1
PCI expansion slot
arbiter 6-7
PCI Host Bridge 4-2
PCI throughput 4-1
PCI/PMC/Expansion 4-2
Peripheral Support 4-2
PHB/SMC
of Hawk ASIC 6-2
PIB controller 6-6
pin assignments
IPMC761 (J3) 5-3
pinouts
J1/P1, RAM500 D-7
PMC
slot 1 arbiter 6-6
slot 2 arbiter 6-7
PMC Carrier Board Placement on
MVME510x 1-15
PMC Interface (Slot 1) 5-1
PMC Interface (Slot 2) 5-1
PMC mode 4-3, 4-7
jumper settings 1-6
PMC Module Placement on MVME510x
1-11
PMC power requirements A-2
PMC slots 2-5
PMCs
installing 1-10
PMCspan-002 Installation on an
MVME510x 1-13
power
requirements A-2
power needs
mvme5100 1-6
power requirements
exclusions A-2
PowerPlus II architecture 4-1