Personal Computer User Manual

http://www.motorola.com/computer/literature IN-5
I
N
D
E
X
PPC6-Bug> 3-2, 3-26
PPC6-Diag> 3-2, 3-26
PPCBug
as initialization firmware 2-4
basics 3-1
commands 3-3
location/size requirements 3-3
overview 3-1
prompt 3-2
PPCBug commands
uses of 3-1
primary PMCspan
installing 1-12
Primary SCSI Bus Negotiations 3-10
Primary SCSI Data Bus Width 3-11
Processor 4-5
product specifications 4-1
programming the MVME510x 6-1
prompt, debugger 3-26
prompts
PPCBug 3-2
R
RAM500
bottom side connector D-7
connectors D-2, D-7
described D-2
expansion module D-1
features D-1
install instructions D-5
memory blocks D-3
SPD addresses D-5
top side connector D-10
Real-Time Clock & NVRAM & Watchdog
Timer 4-8
required equipment 1-2
reset 6-11
RESET and ABORT Switc 4-2
resetting the system 2-1, 6-11
restart mode 3-27
Riscwatch Header 5-1
rogrammable DMA Controller 4-2
ROM Boot Enable 3-13
ROMboot enable 3-13, 3-16
S
SBC mode 4-3
jumper settings 1-6
SCSI bus 3-10
SCSI bus reset on debugger startup 3-10
SD command 3-26
SDRAM clocks for RAM500 D-5
secondary PMCspan
installing 1-14
Secondary SCSI identifier 3-11
set environment to bug/operating system
(ENV) 3-7
setup terminal 1-17
SGS-Thomson MK48T559 timekeeper de-
vice 6-11
Soldered Flash Protection 5-1
sources of reset 6-11
SPD D-13
SPD addresses
for RAM500 D-5
specifications
MBX board A-1
MVME510x A-1
SRO 4-8
stop bit per character 2-3
switch
abort 2-1
reset 2-1
switches 2-1
switches, MVME510x front panel 2-1
SYSFAIL* 3-10
system console, connecting 1-17
system controller 1-17
System Controller (VME) 5-1
system controller function 2-2
System Memory Controller and PCI Host
Bridge 4-5
system reset signal 2-1