Personal Computer User Manual

Preparation

http://www.motorola.com/computer/literature 1-5

Refer to the section titled Jumper Settings on the next page for additional

information.

Note 1. Write protects only outer two 8K boot sectors. Refer to Flash

Memory on page 4-5 for an complete explanation.

Jumper Settings

Prior to performing the installation instructions, you must ensure that the

jumpers are set properly for your particular configuration. For example, if

you are using an IPMC761/MVME761 or IPMC712/MVME712

combination in conjunction with the MVME5100, you must reset the

jumpers for the SBC mode (jumpers J4, J6, J10, J17 and J20). These are

factory configured for the PMC mode. Verify all settings according to the

previous table and follow the instructions below if applicable.

J15 System Controller (VME) Pins 1, 2 for No SCON

Auto

SCON

Pins 2, 3 for Auto SCON

No Jumper for ALWAYS SCON

J16 Soldered Flash Protection Pins 1, 2 Enables Programming of

Flash

Prog.

Enabled

Pins 2, 3 Disables Programming of the

upper 64KB of Flash

Table 1-1. Manually Configured Headers/Jumpers (Continued)

Jumper Description Setting Default