Personal Computer User Manual

1-16 Computer Group Literature Center Web Site

Hardware Preparation and Installation

7. Gently press the two PMCspan modules together and verify that P3

is fully seated in J3.

8. Insert the four screws (Phillips type) through the holes at the corners

of PMCspan-010 and into the standoffs on the primary

PMCspan-002. Tighten screws securely.

Note The screws have two different head diameters. Use the screws

with the smaller heads on the standoffs next to VMEbus

connectors P1 and P2.

MVME5100

Before installing the MVME5100 into your VME chassis, ensure that the

jumpers are configured properly. This procedure assumes that you have

already installed the PMCspan(s) and any PMCs that you have selected.

Perform the following steps to install the MVME5100 in your VME

chassis:

Warning

Dangerous voltages, capable of causing death, are present in this

equipment. Use extreme caution when handling, testing, and adjusting.

Caution

Inserting or removing modules with power applied may result in damage

to module components. Avoid touching areas of integrated circuitry, static

discharge can damage these circuits

1. Attach an ESD strap to your wrist. Attach the other end of the ESD

strap to an electrical ground. Note that the system chassis may not

be grounded if it is unplugged. The ESD strap must be secured to

your wrist and to ground throughout the procedure

2. Perform an operating system shutdown. Turn the AC or DC power

off and remove the AC cord or DC power lines from the system.

Remove chassis or system cover(s) as necessary for access to the

VME module