Personal Computer User Manual

3-10 Computer Group Literature Center Web Site
PPCBug Firmware
3
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Y NVRAM (PReP partition) header space will be
initialized automatically during board initialization,
but only if the PReP partition fails a sanity check.
(Default)
N NVRAM header space will not be initialized
automatically during board initialization.
Y Enable PReP-style network booting (same boot image
from a network interface as from a mass storage
device).
N Do not enable PReP-style network booting. (Default)
Y Negate the VMEbus SYSFAIL
∗ signal during board
initialization.
N Negate the VMEbus SYSFAIL
∗ signal after
successful completion or entrance into the bug
command monitor. (Default)
Y Local SCSI bus is reset on debugger setup.
N Local SCSI bus is not reset on debugger setup.
(Default)
A Asynchronous SCSI bus negotiation. (Default)
S Synchronous SCSI bus negotiation.
N None.