Installation guide

22 M-eMTA Installation Guide
6. Secure the cables using the bushing. For more information, see “Securing
the Cables” on page 31.
7. Slide the AC power supply modules (left and right) into the power supply
enclosure area.
8. Insert the blade(s) into the chassis. For more information, see “Installing the
Blades” on page 29.
9. Reattach the protective shields over the AC1 and AC2 terminal blocks.
10. Place the chassis onto the wall mount bracket. For more information, see
“Mounting the Chassis Onto the Wall Bracket” on page 29.
11. Plug the power supply cord into a 120V electrical outlet.
12. Verify that the unit is operational by observing the LED’s on the blades by
checking for a dial tone and if calls are being sent and received.
WARNING: You must put on an Electrostatic Discharge (ESD) wristband
before continuing.