Installation guide

24 M-eMTA Installation Guide
6. Secure the power cables using the cable strain relief bracket. For more infor-
mation, see “Securing the Cables” on page 31.
7. Slide the AC power supply modules (left and right) into the power supply
enclosure area.
8. Insert the blade(s) into the chassis. For more information, see “Installing the
Blades” on page 29.
9. Reattach the protective shields over the AC1 and AC2 terminal blocks.
10. Verify that the unit is operational by observing the LEDs on the blades, check-
ing for a dial tone, and making sure that calls can be made using the tele-
phone lines.
WARNING: You must put on an Electrostatic Discharge (ESD) wristband
before continuing.