Specifications

Radio Communications 4-19
To set the cradle pairing mode, scan the appropriate bar code below.
Lock Override
In Point-to-Point mode, scan Lock Override when, in some circumstances, it may be necessary to override a locked scanner base
pairing and connect a new scanner. Scan Lock Override followed by the pairing bar code on the cradle.
Pairing Methods
There are two pairing methods. The default method allows the scanner and cradle to pair (connect) when the pairing bar code on the
cradle is scanned. A second method pairs the scanner and cradle when the scanner is inserted in the cradle. To enable this feature,
scan Enable Pair On Contacts below. With this feature enabled it is not necessary to scan the pairing bar code on the cradle. If the
pairing is successful, a low/high connection beep sequence sounds a few seconds after the scanner is placed in the cradle. See
Wireless Beeper Definitions on page 4-5 for other beep sequences.
To enable or disable pairing on contacts, scan the appropriate bar code below.
*Unlocked Pairing Mode
Locked Pairing Mode
LockOverride
Enable Pair On Contacts
*Disable Pair on Contacts