Scanner User Manual

Symbol LS7708 Product Reference Guide6-6

RS-232 Default Parameters

Table 6-1 lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s) beginning in RS-232

Host Parameters on page 6-7.

Scanning parameter setting bar codes with the primary scanner also changes settings on the auxiliary

scanner.

See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and

miscellaneous default parameters.

Table 6-1. RS-232 Host Default Table

Parameter Default Page Number

RS-232 Host Parameters

RS-232 Host Types Standard

6-9

Baud Rate 9600 6-13

Parity None 6-17

Check Receive Errors Enable 6-20

Hardware Handshaking None 6-21

Software Handshaking None 6-24

Host Serial Response Time-out 2 Sec 6-26

RTS Line State Low RTS 6-29

Stop Bit Select 1 6-30

Data Bits 8-Bit 6-31

Beep on <BEL> Disable 6-32

Intercharacter Delay 0 msec 6-33

Nixdorf Beep/LED Option Normal Operation 6-35

Ignore Unknown Characters Send Bar Codes 6-37

User selection is required to configure this interface and this is the most common selection.

Note