Switch User Guide
Table Of Contents
- UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
- Status LEDS
- Physical Specifications
- Technical Specifications
- T1 Channel Mode
- E1 Channel Mode
- Alternate Mark Inversion (AMI)
- The 1 in 15 Requirement (AMI)
- Binary Eight Zero Substitution Coding
- High Density Bipolar Order Three Encoding
- Master and Secondary Clocks
- Loss of Clock Signal
- Timing Modes
- Loopback Timing Mode
- Recovered Timing Mode
- Network Timing Scenarios
- INSTALLING AND CONFIGURING YOUR CANOPY T1/E1 MULTIPLEXERS
- MANAGING YOUR CANOPY T1/E1 MULTIPLEXERS
- CANOPY T1/E1 MULTIPLEXER REFERENCE INFORMATION
- Canadian Compliance Statement
- Statement of Compliance
Canopy T1/E1MultiplexerSeptember2004
T1/E1MultiplexerFPGAVersion3.4
Page48 of 73
2.5.2 ChangingtheAdministratorPassword
There is only one account for the Canopy T1/E1 Multiplexer—the administrator account.
The username may not be changed, however the password may be changed at any time.
Figure 19: Change Password dialogue box
Procedure 15: Changing Administrator password using the EMS
Use this procedure to change the password from the EMS.
1. Select File→Change password from the main menu.
RESULT: The Change Password dialogue box opens (shown in Figure 19).
2. Type the old password, then press Enter or Tab.
3. Type the new password, then press Enter or Tab.
4. Enter the new password again, then press Enter or Tab.
5. To accept, click Change.
To reject, click Cancel.
end of procedure
Issue3