Switch User Guide
Table Of Contents
- UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
- Status LEDS
- Physical Specifications
- Technical Specifications
- T1 Channel Mode
- E1 Channel Mode
- Alternate Mark Inversion (AMI)
- The 1 in 15 Requirement (AMI)
- Binary Eight Zero Substitution Coding
- High Density Bipolar Order Three Encoding
- Master and Secondary Clocks
- Loss of Clock Signal
- Timing Modes
- Loopback Timing Mode
- Recovered Timing Mode
- Network Timing Scenarios
- INSTALLING AND CONFIGURING YOUR CANOPY T1/E1 MULTIPLEXERS
- MANAGING YOUR CANOPY T1/E1 MULTIPLEXERS
- CANOPY T1/E1 MULTIPLEXER REFERENCE INFORMATION
- Canadian Compliance Statement
- Statement of Compliance
Canopy T1/E1MultiplexerSeptember2004
T1/E1MultiplexerFPGAVersion3.4
Page61 of 73
3.7 LICENSEKEYUPGRADES
As previously described, you can transform any single-port enabled Canopy T1/E1
Multiplexer into a 2-port, 3-port, or 4-port multiplexer through the purchase and
installation of license keys from your Canopy distributor.
Procedure 30: Installing a license key to enable an additional port
To install a license key on a Canopy T1/E1 Multiplexer, perform the following steps.
1. From the main menu of the EMS, select Config→T1/E1 Port Upgrade
Config→Software Upgrade (shown in Figure 15 on Page 33).
RESULT: The Canopy T1/E1 Port Upgrade window opens, as shown in
Figure 26.
Figure 26: T1/E1 Port Upgrade window
2. Type in the upgrade key that your Canopy distributor provided for this unit, then
press Enter.
3. Click Done.
RESULT: If the upgrade succeeded, then the Key accepted window appears
(see Figure 27).
If the upgrade failed, then the Failed: Invalid key entry window appears (see
Figure 28).
Figure 27: Key accepted window
Issue3