Switch User Guide
Table Of Contents
- UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
- Status LEDS
- Physical Specifications
- Technical Specifications
- T1 Channel Mode
- E1 Channel Mode
- Alternate Mark Inversion (AMI)
- The 1 in 15 Requirement (AMI)
- Binary Eight Zero Substitution Coding
- High Density Bipolar Order Three Encoding
- Master and Secondary Clocks
- Loss of Clock Signal
- Timing Modes
- Loopback Timing Mode
- Recovered Timing Mode
- Network Timing Scenarios
- INSTALLING AND CONFIGURING YOUR CANOPY T1/E1 MULTIPLEXERS
- MANAGING YOUR CANOPY T1/E1 MULTIPLEXERS
- CANOPY T1/E1 MULTIPLEXER REFERENCE INFORMATION
- Canadian Compliance Statement
- Statement of Compliance
Canopy T1/E1MultiplexerSeptember2004
T1/E1MultiplexerFPGAVersion3.4
Page67 of 73
4 CANOPYT1/E1MULTIPLEXERREFERENCE
INFORMATION
4.1 CLICOMMANDSTOGETSTATUSINFORMATION
Desired Action Syntax, Response, and Description
Get Canopy-side
Ethernet auto-
negotiation
Enter get canopy port auto negotiation
The system responds
Canopy port auto-negotiation is: [on/off]
Gets the auto-negotiation mode for the Canopy BH Ethernet port. If
auto negotiation is set to OFF, the port will be forced to 100 Mbps Full
Duplex.
Get LAN-side
Ethernet auto-
negotiation
Enter get lan port auto negotiation
The system responds
LAN port auto-negotiation is: [on/off]
Get the auto-negotiation mode for the customer LAN Ethernet port. If
auto negotiation is set to OFF, the port will be forced to 100 Mbps Full
Duplex.
Get line type
Enter get type
The system responds
Line type [T1/E1]
Gets the line type, either T1 or E1. All four ports have the same line
type.
Issue3