Switch User Guide
Table Of Contents
- UNDERSTANDING THE CANOPY T1/E1 MULTIPLEXER
- Status LEDS
- Physical Specifications
- Technical Specifications
- T1 Channel Mode
- E1 Channel Mode
- Alternate Mark Inversion (AMI)
- The 1 in 15 Requirement (AMI)
- Binary Eight Zero Substitution Coding
- High Density Bipolar Order Three Encoding
- Master and Secondary Clocks
- Loss of Clock Signal
- Timing Modes
- Loopback Timing Mode
- Recovered Timing Mode
- Network Timing Scenarios
- INSTALLING AND CONFIGURING YOUR CANOPY T1/E1 MULTIPLEXERS
- MANAGING YOUR CANOPY T1/E1 MULTIPLEXERS
- CANOPY T1/E1 MULTIPLEXER REFERENCE INFORMATION
- Canadian Compliance Statement
- Statement of Compliance
Canopy T1/E1MultiplexerSeptember2004
T1/E1MultiplexerFPGAVersion3.4
Page73 of 73
4.4 REFERENCES
This document refers to the following documents:
◦ American National Standards Institute. ANSI T1.101-1999 – Telecommunication
Synchronization Interface Standards.
◦ American National Standards Institute. ANSI T1.105.09-1996 – Synchronous
Optical Network (SONET) Network Element Timing and Synchronization.
◦ American National Standards Institute. ANSI T1.403-1989 - Carrier to customer
installation - DS1 metallic interface.
◦ Cleveland, Robert F., Jr., David M. Sylvar and Jerry L. Ulcek. Federal
Communications Commission, Office of Engineering and Technology. OET
Bulletin No. 65. Edition 97-01 (August, 1997). Evaluation Compliance with FCC
Guidelines for Human Exposure to Radiofrequency Electromagnetic Fields.
◦ European Telecommunications Standard ETS 300 328, 2
nd
Edition, (November,
1996). Radio Equipment and System (RES); Wideband Transmission Systems;
Technical characteristics and test conditions for data transmission equipment
operating in the 2,4 GHz ISM band and using spread spectrum modulation
techniques.
◦ National Electrical Code (NEC), Chapter 800, Article 810, Radio and Television
Equipment.
◦ ITU-T Recommendation G.703
◦ ITU-T Recommendation G.823
Issue3