Operation Manual
28 Base settings
NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process.
On the base:
1. Press and hold P for 5 seconds. The base will remain in registration mode for 90
seconds.
On the handset:
1. If the handset is not register to a base press m and then enter the 4 digit PIN code
(default = 0000) and press m.
2. If the handset is already register to a base press m, scroll d to
ADVANCED SET
and
press m.
3. Scroll d to
REGISTER
and press m.
4. The display will ask for the PIN to be entered. Enter the 4 digit PIN code (default =
0000) and press m. You will hear a beep if the registration is successful. The handset
is automatically assigned an available handset number. Use this number when making
internal calls.
NOTE
If registration is not successful the rst time, please repeat the process again in case the
base registration period ran out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 4 handsets registered to the base, the registration will fail. You must
de-register another handset before you can register a new one.
8.8 De-register a handset
Use one handset to de-register another. You cannot de-register the handset that you are
using.
1. Press m, scroll d to
ADVANCED SET
and press m.
2. Scroll d to
UNREGISTER
and press m.
3. Enter the 4 digit PIN code (default = 0000) and press m.
4. Scroll u or d to select the handset number that you want to de-register and press m.
You will hear a conrmation beep and the display will return to the previous menu.
8.9 Restore default settings
You can restore your T1 to its default (original) settings.
All the handsets that are registered to the base will be retained.
IMPORTANT
Resetting your phone to its default settings will delete all entries in the Calls and Redial