Installation manual

INSTALLATION MTM700/MTM800 Mobile Terminal / Installation Manual 31

INSTALLATION

Introduction

General Information

There are two methods of installing the mobile terminal in a vehicle:

1. Using the direct mounting trunnion and power cables supplied with a standard radio package.

2. Remote mounted in the car radio cut-out (using the required DIN mounting kit RLN4781A),

per ISO7736.

An accessory connector on the rear of the terminal enables you to attach different accessories (see

section “Accessory Connection Plan”).

A 10-pin telephone type connector (TELCO) on the front control head panel (see page 67) provides

for the connection of various types of microphones (fist microphone GMM4063, desktop microphone

GMMN4064, telephone style handset GMUN1006).

1. Mount the terminal horizontally near the driver, so the driver can easily view, access and

operate the controls and accessories.

2. Ensure that the location is not exposed to dirt and moisture.

3. Verify that there will be sufficient space around the mobile unit for air flow and installation.

4. Check that there is enough routing space for the power cable connector and the antenna

coaxial cable.

5. Plan the best place to run connections to minimize pinching, crushing, and overheating of

wires and cables.

NOTE

This product must be installed in a vehicle in accordance with the vehicle manu-

facturer’s guidelines and the instruction detailed in this manual.

Only the specified Motorola parts in this manual should be used. Failure to do so

could result in non compliance to the Automotive Directive (72/245/EEC, as

amended by 95/54/EC).

Note, for products fitted to two and three wheeled vehicles, Directive 97/24/EC

applies.

This Terminal is only designed and certified to be used for terrestrial use only.

TERMINA

SPECIFIC

NOTE

This terminal is ONLY made for 12 V power supply connection. In vehicles with

24 V power supply, a DC/DC converter is required.

Please be aware when planning the installation that there is a current con-

sumption of approx. 3.5A during PTT and even 30mA when terminal is switched

off."

NOTE

In a vehicle with an airbag, make sure that the mounting location of the mobile ter-

minal, or of any terminal accessory, is not in the deployment path of the air bag.