Installation manual

INSTALLATION MTM700/MTM800 Mobile Terminal / Installation Manual 35

Ignition Sense Cable Installation

The HKN9327 Ignition Sense Cable allows the terminal to be turned on and off by the vehicle igni-

tion switch.

The ignition sense cable kit contains a thin cable and a fuse holder. To install the cable, carry out the

following steps.

1. Plug the lead of the Ignition Sense Cable with the crimped on terminal into #10 socket of the

accessory plug.

2. Route and secure the cable with attached tie wrap.

3. Connect the other lead of the accessory cable to the ignition switch of the vehicle.

4. Insert the fuse into the fuse holder and close the cover.

Figure 3 Accessory Connector with Ignition Sense Cable

Table 2 Ignition Sense Cable

Number Description Rating

HKN9327 Ignition Sense Cable with fuse 4A Ignition Sense Cable, Length: 3 m

6580283E02 Fuse 4A for Ignition Sense Cable

In case of blown fuses ONLY replace those with identically value.

NEVER insert different values.

Ensure that during cable installation the fuse is removed.

C a u t i o n