Installation manual

38 MTM700/MTM800 Mobile Terminal / Installation Manual INSTALLATION
Installation Procedure
1. Select either the transmission hump or an open underneath portion of the dash to mount your
terminal. (See Figure 7 Transmission Hump Mounting (Top) and Below Dash Mounting
(Bottom)). When mounting the trunnion on the transmission hump, be careful that the
transmission housing is not affected.
2. Use the trunnion mounting bracket as a template, to mark the hole positions on the mounting
surface. Use the innermost three holes for a curved mounting surface, such as the
transmission hump, and the three outermost holes for a flat surface such as under the dash.
3. Center-punch the spots you marked and use a 4 mm (5/32-inch) bit to drill a hole at each
location.
4. Secure the trunnion mounting bracket to the mounting surface with the three self-tapping
screws provided. (See Figure 7 Transmission Hump Mounting (Top) and Below Dash
Mounting (Bottom)).
5. Slide the terminal into the trunnion. Secure the terminal with the two wing screws provided.