Installation manual

INSTALLATION MTM700/MTM800 Mobile Terminal / Installation Manual 45
Assembling the Back Housing for Remote Mount to the Standard Control Head
1. Remove the Standard Control Head from the Transceiver by inserting the dismantling tool
(Motorola part number 6686119B01) in the recess between the Standard Control Head and
the Transceiver.
2. Remove the flex from the Transceiver only.
3. Press the dismantling tool until the snap connectors on the side of the back housing release
from the Standard Control Head.
4. Split the Standard Control Head into front and back housings by inserting the demount tool in
the recess between them.
Figure 12 Control Head Back Housing Removal
Table 6: Associated Components Remote Mount Expansion Kit
Description Part Number
Remote Mount Expansion Kit, 3 m
PMLN4495_
Data Expansion Control Head Kit GMCE4053_
Back Housing for Remote Mount Kit GMCN4060_
Remote Mount Cable, 3 m RKN4077_
Speaker Extension Cable GMKN4084_
Remote Mount Expansion Kit, 5 m
PMLN4496_
Data Expansion Control Head Kit GMCE4053_
Back Housing for Remote Mount Kit GMCN4060_
Remote Mount Cable, 5 m RKN4078_
Speaker Extension Cable GMKN4084_
Remote Mount Expansion Kit, 7 m
PMLN4497_
Data Expansion Control Head Kit GMCE4053_
Back Housing for Remote Mount Kit GMCN4060_
Remote Mount Cable, 7 m RKN4079_
Speaker Extension Cable GMKN4084_
CAUTION: The 10 pin Telco connector can only be used to connect a remote mount
Standard Control Head. Connecting any other accessories (e.g. microphone) might
result in malfunctioning hardware failure.
NOTE
To minimize cosmetic damage disassemble from the bottom side (label side).
!
C a u t i o n
ZWG0130214-O