Installation manual

INSTALLATION MTM700/MTM800 Mobile Terminal / Installation Manual 55
Configuration with Y-Adapter (Chinese version, MTM700 only)
Figure 19 Motorcycle Configuration with Y-Adapter
MOTORCYCLE
SPECIFIC
NOTE
The fist microphone (GMMN4063_) will be delivered with a coiled cord cable
which does not fit into the rear side accessory plug of the transceiver and
therefore must be replaced by the cable GMKN4072_.
To unscrew the coiled cord cable supplied with the fist microphone:
1. Rotate the locking collar at the base of the microphone in a
counterclockwise direction until it stops.
2. Pull the coiled cord cable out and away from the base of the microphone.
3. Install the coiled cord cable (GMKN4072_) in the reverse order of
removal.
4. Mount the new cable at the rear side as shown in a separate installation
leaflet supplied with the cable GMKN4072_.
8 wire RS232 Interface
Data
Terminal
Motorcycle
Control Head
MTM700/800
Transceiver
Box
Expansion Head
Customized Adapter
Cable:
RKN4077
non-Motorola
Accessories:
to e.g. Helmet with
Microphone and
Earpiece,
external PTT, etc.
Coiled Cord Cable
GMKN4072
for Fist Mic GMMN4063
Accessory Connector (20 Pin)
BNC Antenna
Connector
Cable:
3066516B02
TELCO RJ45
Connector
(10 Pin)
25 Pin subD
Connector
(female)
9 Pin subD
Connector
(female)
RS232
Interface
Contacts for:
- External Speaker
- Ignition Sense Cable
- Emergency
Top view to the chassis
Y-Adapter kit
GMKN4197_
ESBEP
Interface
Expansion Conn.
(7 Pin / MTM700 only)
Power Connector
FME GPS Conn. (MTM800 only)