Installation manual

INSTALLATION MTM700/MTM800 Mobile Terminal / Installation Manual 59
Expansion Head Radio with Control Terminal & Data Terminal
This configuration allows controlling the radio (Transceiver Box) with a Control Terminal (e.g. Per-
sonal Computer, Laptop, Console etc.). In this configuration the Control Terminal is a substitute for
the Standard Control Head. The Control Terminal will be connected to the 25 pin socket of the
Expansion Head via the cable GMKN4079 (see section „Connecting Cable“ for more information).
A Data Terminal (e.g. Personal Computer, Laptop, Console etc.) can be connected in addition to the
9 pin subD connector by using the 8-wires RS232 interface to send/receive packet data or short
pakket data. The connecting cable is a standardized RS232 cable and is available in PC shops.
Both, the Control Terminal as well as the Data Terminal can be used at the same time.
Figure 24 Configuration with Remote Control Terminal and Data Terminal
Expansion Conn.
(7 Pin / MTM700 only)
Accessory
Connector (20 Pin)
Power Connector
BNC Antenna
Connector
FME GPS Conn. (MTM800 only)
8 wire RS232 Interface
Data
Terminal
MTM700/800
Transceiver
Box
Expansion Head
Control
Terminal
(SB9600 protocol)
TELCO
Connector
(10 Pin)
25 Pin subD
Connector
(female)
9 Pin subD
Connector
(female)
RS232
Interface
Top view to the chassis
RS232
Interface
Cable: GMKN4079
SB9600
Interface