Installation manual
Table Of Contents
- COPYRIGHT
- IMPORTANT SAFETY INFORMATION
- DOCUMENT HISTORY
- CONTENTS
- SCOPE
- MODEL INFORMATION & ACCESSORIES
- INSTALLATION
- Introduction
- DC Power Cable Installation
- Ignition Sense Cable Installation
- Terminal Installation
- Enhanced Control Head Installation
- Trunnion Installation
- Dashboard Installation
- Desktop Installation
- Remote Mount Installation
- Installing the Remote Mount Enhanced Control Head onto the Remote Mount Trunnion
- Installing the Remote Mount Enhanced Control Head in a DIN Mount Bracket
- Inserting the Remote Mount Enhanced Control Head with the DIN Mount Bracket into the DIN Frame
- Adding Extra Connectivity to the Remote Head
- Installing the Accessories Expansion Cable
- Motorcycle Mount Enhanced Control Head Installation
- Data Expansion Head Enhanced Installation
- Connectors and Pin Assignment of the Radio
- Connectors and Pin Assignment of Data Expansion Head Enhanced and Remote Head Enhanced
- Connector and Pin Assignment of the Enhanced Control Head
- Connecting Cables
- Motorcycle Mount Enhanced Control Head-to-Remote Head Enhanced/Data Expansion Head Enhanced (Motorcycle Mount TELCO Cable)
- Remote Mount Enhanced Control Head/Motorcycle Mount Enhanced Control Head-to-Accessories (Accessories Expansion Cable)
- Radio-to-Junction Box
- Data Expansion Head Enhanced Radio-to-Data Device
- Data Expansion Head Enhanced Radio-to-Fist Microphone
- Radio-to-Data Device: Active Data Cable
- Vehicle Antenna Installation
- External Speaker Installation
- UPGRADING THE TERMINAL
- APPENDIX
26 MTM800 Enhanced Mobile Terminal Installation Manual MODEL INFORMATION & ACCESSORIES
1) Keep the GCAI connector cover supplied with the new Control Head.
2) Requires Junction Box, GMLN3002.
3) The GCAI handset is only approved for Remote and Motorcycle installations used with Toroid EMC Suppression kit
(P/N:
01015001001). The handset is certified to 350–390 MHz and 380–430 MHz frequency ranges only. The handset is not
certified for 410–470 MHz and 806–870 MHz with any installation type.
4) The cable, GMKN1022, is only compatible when an Data Expansion Head Enhanced is not fitted as part of a remote mount
configuration. In this configuration access to the Tetra PEI for IP Packet Data and SDS services is available on the Data
Expansion Head Enhanced and the Active Data Cable GMKN1022 is not required.
Installation Part Number M1 M2 M3 M4 M5
External Alarm Relay GKN6272 X X X X
Accessory Connector Kit GMBN1021 X X X X
Buzzer Kit GLN7282 X X X X
Mounting (Transceiver) Part Number M1 M2 M3 M4 M5
Key Lock Mount RLN4779 X X X X X
High Profile Mounting Bracket GLN7317 X X X X X
Low Profile Mounting Bracket GLN7324 X X X X X
Mounting Frame to Install Transceiver in DIN-A Slot PMLN5094 X X X X X
Mounting (Control Head) Part Number M1 M2 M3 M4 M5
Remote Mount Trunnion Kit PMLN4912 X
Motorcycle Mount Trunnion Kit PMLN5092 X
DIN Mount Bracket PMLN5093 X
Programming/Data Part Number M1 M2 M3 M4 M5
Programming Cable GMKN4067 X X X X
Active Data Cable GMKN1022 X
X
4
X X
USB Programming Cable (Mobile Microphone Port) HKN6184 X X X X
I85 USB Data Cable with Inline Power NNTN4007 X X X X
ACCESSORIES