Installation manual
Table Of Contents
- COPYRIGHT
- IMPORTANT SAFETY INFORMATION
- DOCUMENT HISTORY
- CONTENTS
- SCOPE
- MODEL INFORMATION & ACCESSORIES
- INSTALLATION
- Introduction
- DC Power Cable Installation
- Ignition Sense Cable Installation
- Terminal Installation
- Enhanced Control Head Installation
- Trunnion Installation
- Dashboard Installation
- Desktop Installation
- Remote Mount Installation
- Installing the Remote Mount Enhanced Control Head onto the Remote Mount Trunnion
- Installing the Remote Mount Enhanced Control Head in a DIN Mount Bracket
- Inserting the Remote Mount Enhanced Control Head with the DIN Mount Bracket into the DIN Frame
- Adding Extra Connectivity to the Remote Head
- Installing the Accessories Expansion Cable
- Motorcycle Mount Enhanced Control Head Installation
- Data Expansion Head Enhanced Installation
- Connectors and Pin Assignment of the Radio
- Connectors and Pin Assignment of Data Expansion Head Enhanced and Remote Head Enhanced
- Connector and Pin Assignment of the Enhanced Control Head
- Connecting Cables
- Motorcycle Mount Enhanced Control Head-to-Remote Head Enhanced/Data Expansion Head Enhanced (Motorcycle Mount TELCO Cable)
- Remote Mount Enhanced Control Head/Motorcycle Mount Enhanced Control Head-to-Accessories (Accessories Expansion Cable)
- Radio-to-Junction Box
- Data Expansion Head Enhanced Radio-to-Data Device
- Data Expansion Head Enhanced Radio-to-Fist Microphone
- Radio-to-Data Device: Active Data Cable
- Vehicle Antenna Installation
- External Speaker Installation
- UPGRADING THE TERMINAL
- APPENDIX
INSTALLATION MTM800 Enhanced Mobile Terminal Installation Manual 27
INSTALLATION
Introduction
General Information
There are two methods of installing the mobile terminal in a vehicle:
1. Using the direct mounting trunnion and power cables supplied with a standard radio package.
2. Remote mounted in the car radio cut-out (using the required DIN mounting kit PMLN5094),
per ISO7736.
An accessory connector on the rear of the terminal enables you to attach different accessories (see
section
“Accessory Connection Plan”).
A mobile microphone port on the front control head panel (see page 66) provides for the connection
of various types of microphones (Desktop Microphone RMN5106, fist microphone RMN5053).
1. Mount the terminal horizontally near the driver, so the driver can easily view, access and
operate the controls and accessories.
2. Ensure that the location is not exposed to dirt and moisture.
3. Verify that there will be sufficient space around the mobile unit for air flow and installation.
4. Check that there is enough routing space for the power cable connector and the antenna
coaxial cable.
5. Plan the best place to run connections to minimize pinching, crushing, and overheating of
wires and cables.
This product must be installed in a vehicle in accordance
with the vehicle manufacturer’s guidelines and the
instruction detailed in this manual.
Only the specified Motorola parts in this manual should be
used. Failure to do so could result in non compliance to
the Automotive Directive (72/245/EEC, as amended by
95/54/EC).
For products fitted to two and three wheeled vehicles,
Directive 97/24/EC applies.
This Terminal is only designed and certified to be used for
terrestrial use only.
This terminal is ONLY made for 12 V power supply
connection. In vehicles with 24 V power supply, a DC/DC
converter is required.
Please be aware when planning the installation that there
is a current consumption of approx. 3.5 A during PTT and
up to 30 mA when terminal is switched off.