Installation manual
Table Of Contents
- COPYRIGHT
- IMPORTANT SAFETY INFORMATION
- DOCUMENT HISTORY
- CONTENTS
- SCOPE
- MODEL INFORMATION & ACCESSORIES
- INSTALLATION
- Introduction
- DC Power Cable Installation
- Ignition Sense Cable Installation
- Terminal Installation
- Enhanced Control Head Installation
- Trunnion Installation
- Dashboard Installation
- Desktop Installation
- Remote Mount Installation
- Installing the Remote Mount Enhanced Control Head onto the Remote Mount Trunnion
- Installing the Remote Mount Enhanced Control Head in a DIN Mount Bracket
- Inserting the Remote Mount Enhanced Control Head with the DIN Mount Bracket into the DIN Frame
- Adding Extra Connectivity to the Remote Head
- Installing the Accessories Expansion Cable
- Motorcycle Mount Enhanced Control Head Installation
- Data Expansion Head Enhanced Installation
- Connectors and Pin Assignment of the Radio
- Connectors and Pin Assignment of Data Expansion Head Enhanced and Remote Head Enhanced
- Connector and Pin Assignment of the Enhanced Control Head
- Connecting Cables
- Motorcycle Mount Enhanced Control Head-to-Remote Head Enhanced/Data Expansion Head Enhanced (Motorcycle Mount TELCO Cable)
- Remote Mount Enhanced Control Head/Motorcycle Mount Enhanced Control Head-to-Accessories (Accessories Expansion Cable)
- Radio-to-Junction Box
- Data Expansion Head Enhanced Radio-to-Data Device
- Data Expansion Head Enhanced Radio-to-Fist Microphone
- Radio-to-Data Device: Active Data Cable
- Vehicle Antenna Installation
- External Speaker Installation
- UPGRADING THE TERMINAL
- APPENDIX
28 MTM800 Enhanced Mobile Terminal Installation Manual INSTALLATION
DC Power Cable Installation
Installation Planning
The 3-meter (10-foot) DC power cable shipped with the terminal should be long enough to be
installed in most vehicles. Take the following precautions before you begin:
1. Whenever possible, avoid routing the cable above the catalytic converter.
2. Make sure that the power cable never rests on sharp edges.
3. Use grommets whenever a cable has to pass through a hole in a metal panel.
The following table lists power cables available for this terminal:
In a vehicle with an airbag, make sure that the mounting
location of the mobile terminal, or of any terminal
accessory, is not in the deployment path of the air bag.
Uninstaling the radio
OPTION 1:
Before disconnecting the 13.2 V main power supply from
the radio:
1. Switch off the radio.
2. Wait for a minimum of 4 seconds after the radio switch
is released.
3. Disconnect the 13.2 V main power supply.
OPTION 2:
Turn off the main power supply WITHOUT switching OFF
the radio.
This terminal must be operated only in negative ground
electrical systems. Operating the terminal on a positive
ground system will cause the cable fuse to short-circuit.
Check the vehicle ground polarity before you begin the
installation.
Table 1 DC Power Cables
Number Description Rating
GKN6270 Power Cable to battery with fuse 10 A 12V Power Cable to Battery, Length: 3 m
GKN6274 Power Cable to battery with fuse 10 A 12V Power Cable to Battery, Length: 6 m
HKN9327 * Ignition Sense Cable with fuse 4 A Ignition Sense Cable, Length: 3 m
6500139767 Fuse 10 A for Power Cable
6580283E02 * Fuse 4 A for Ignition Sense Cable