Installation manual
Table Of Contents
- COPYRIGHT
- IMPORTANT SAFETY INFORMATION
- DOCUMENT HISTORY
- CONTENTS
- SCOPE
- MODEL INFORMATION & ACCESSORIES
- INSTALLATION
- Introduction
- DC Power Cable Installation
- Ignition Sense Cable Installation
- Terminal Installation
- Enhanced Control Head Installation
- Trunnion Installation
- Dashboard Installation
- Desktop Installation
- Remote Mount Installation
- Installing the Remote Mount Enhanced Control Head onto the Remote Mount Trunnion
- Installing the Remote Mount Enhanced Control Head in a DIN Mount Bracket
- Inserting the Remote Mount Enhanced Control Head with the DIN Mount Bracket into the DIN Frame
- Adding Extra Connectivity to the Remote Head
- Installing the Accessories Expansion Cable
- Motorcycle Mount Enhanced Control Head Installation
- Data Expansion Head Enhanced Installation
- Connectors and Pin Assignment of the Radio
- Connectors and Pin Assignment of Data Expansion Head Enhanced and Remote Head Enhanced
- Connector and Pin Assignment of the Enhanced Control Head
- Connecting Cables
- Motorcycle Mount Enhanced Control Head-to-Remote Head Enhanced/Data Expansion Head Enhanced (Motorcycle Mount TELCO Cable)
- Remote Mount Enhanced Control Head/Motorcycle Mount Enhanced Control Head-to-Accessories (Accessories Expansion Cable)
- Radio-to-Junction Box
- Data Expansion Head Enhanced Radio-to-Data Device
- Data Expansion Head Enhanced Radio-to-Fist Microphone
- Radio-to-Data Device: Active Data Cable
- Vehicle Antenna Installation
- External Speaker Installation
- UPGRADING THE TERMINAL
- APPENDIX
38 MTM800 Enhanced Mobile Terminal Installation Manual INSTALLATION
Desktop Installation
The MTM800 Enhanced may be desktop mounted. The Desktop Station option provides the
terminal with the desk microphone, power supply, desk top tray (without speaker) and external
loudspeaker.
Planning
Planning is the key to fast, easy terminal installation. Before a hole is drilled or a wire is run, inspect
the location and determine how and where you intend to mount the antenna, terminal and
accessories. Plan wire and cable runs to provide maximum protection from pinching, crushing, and
overheating. The installation planning should only be undertaken by persons who are competent
and able to ensure that the complete installation fulfils its regulatory requirements, such as EMC
(Electro Magnetic Compatibility) and IEC (International Electrotechnical Commission).
Installation
1. Be sure line voltage power is available.
2. Make sure sufficient air can flow around the terminal to permit adequate cooling.
3. Choose a flat surface for the desktop tray and external loudspeaker.
4. Be sure the mounting surface is able to adequately support the weight of the terminal and
tray.
5. If an outdoor antenna is used choose a location for the terminal as close as possible to the
antenna cable inlet of the building. Make sure that the installation of the surge protector is in
accordance with the manufacturer’s specifications and safety hints. The line voltage power
supply shall be grounded properly.
If an outdoor antenna is used a proper grounded Lightning
Protector with Quarter-Wave Shorting Stub must be
inserted between the outdoor antenna and the transceiver
antenna input. The line voltage power supply shall have a
proper ground connection (refer to IEC61312-1). The
installation must meet the requirements of any and all
applicable local codes and regulations.