Installation manual
Table Of Contents
- COPYRIGHT
- IMPORTANT SAFETY INFORMATION
- DOCUMENT HISTORY
- CONTENTS
- SCOPE
- MODEL INFORMATION & ACCESSORIES
- INSTALLATION
- Introduction
- DC Power Cable Installation
- Ignition Sense Cable Installation
- Terminal Installation
- Enhanced Control Head Installation
- Trunnion Installation
- Dashboard Installation
- Desktop Installation
- Remote Mount Installation
- Installing the Remote Mount Enhanced Control Head onto the Remote Mount Trunnion
- Installing the Remote Mount Enhanced Control Head in a DIN Mount Bracket
- Inserting the Remote Mount Enhanced Control Head with the DIN Mount Bracket into the DIN Frame
- Adding Extra Connectivity to the Remote Head
- Installing the Accessories Expansion Cable
- Motorcycle Mount Enhanced Control Head Installation
- Data Expansion Head Enhanced Installation
- Connectors and Pin Assignment of the Radio
- Connectors and Pin Assignment of Data Expansion Head Enhanced and Remote Head Enhanced
- Connector and Pin Assignment of the Enhanced Control Head
- Connecting Cables
- Motorcycle Mount Enhanced Control Head-to-Remote Head Enhanced/Data Expansion Head Enhanced (Motorcycle Mount TELCO Cable)
- Remote Mount Enhanced Control Head/Motorcycle Mount Enhanced Control Head-to-Accessories (Accessories Expansion Cable)
- Radio-to-Junction Box
- Data Expansion Head Enhanced Radio-to-Data Device
- Data Expansion Head Enhanced Radio-to-Fist Microphone
- Radio-to-Data Device: Active Data Cable
- Vehicle Antenna Installation
- External Speaker Installation
- UPGRADING THE TERMINAL
- APPENDIX
46 MTM800 Enhanced Mobile Terminal Installation Manual INSTALLATION
Figure 17 Motorcycle Installation
Installing the Motorcycle Mount Enhanced Control Head
1. Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps
into place.
2. Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount
Enhanced Control Head for an optimum view of the display. Then, complete the tightening of
the screws.
3. There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of
allowable movement, as shown in
Figure 18 and Figure 19:
If an additional GPS antenna or a combined TETRA/GPS
antenna is used, the antenna housing carries the GPS
receiver. Take care not to cover the antenna housing with
metal or other radio wave absorbing material.
TRANSCEIVER
LOUDSPEAKER
FIST MICROPHONE
MOTORCYCLE BOX
ANTENNA
BATTERY
FUSE
BLOCK
IGNITION SENSE CABLE
P/N: HKN9327 (3m, FUSE 4A)
CHASSIS GROUND
FUSED POWER CABLE
P/N: GKN6270 (3m, FUSE 10A)
MOTOCYCLE MOUNT ENHANCED CONTROL HEAD
TRANSCEIVER-TO-CONTROL HEAD CABLE
P/N: PMKN4030
FIST MICROPHONE CABLE
P/N: GMKN4072