Specifications

2 - 6 VC6000 Series Product Reference Guide
6 Pin Deutsch Telemetry Cable
The 6 Pin Deutsch Telemetry Cable supports protocol 1708 interface with Heavy-Duty type bus (SAE J1708)
1. Connect J1 serial connector into the Auxiliary port of the VC6000 Series (see Figure 2-6). Close the
connector’s fastening screws.
2. Connect J2 plug to the telemetry receptacles of the vehicle data bus (see Table 2-2).
Figure 2-6 6 Pin Deutsch Telemetry Cable
9 Pin Deutsch Telemetry Cable
1. Connect J1 serial connector into the Auxiliary port of the VC6000 Series (see Figure 2-7). Close the
connector’s fastening screws.
2. Connect J2 plug to the telemetry receptacles of the vehicle data bus (see Table 2-2).
Figure 2-7 9 Pin Deutsch Telemetry Cable
NOTE The 6 Pin Deutsch Telemetry Cable only supports heavy-duty vehicle bus type SAE J1708.
NOTE Use the 50 Pin Accessory Cable (see 50 Pin Accessory Cable on page 2-7) to adapt betwwen the 6 Pin Deutsch
Telemetry Cable and the Auxiliary port of the VC6000 Series.
J1, 9 PIN (D-type - Male) to VC6000 Series Auxiliary port
via 50 Pin Accessory Cable
J2 to vehicle Deutsch 6 Connector (HD16-6-12s)
NOTE Use the 50 Pin Accessory Cable (see 50 Pin Accessory Cable on page 2-7) to adapt betwwen the 9 Pin Deutsch
Telemetry Cable and the Auxiliary port of the VC6000 Series.
J2 To vehicle Deutsch 9 Connector
(HD17-9-1939s)
J1 (D-type - Male) to VC6000 Series Auxiliary Port via 50
Pin Accessory Cable