User's Guide
Table Of Contents
- 1. Safety Instructions
- 2. Getting Started
- 2.1 Baby Unit Power Supply
- 2.2 Parent Unit Battery Installation
- 2.3 Parent Unit Power Supply
- 2.4 Desktop Stand of the Parent Unit
- 3. Using the Baby Monitor
- 3.1 Setting Up
- 3.2 Power On or Off the Baby Unit
- 3.3 Power On or Off the Parent Unit
- 3.4 Night Vision Mode
- 3.5 Turn off Parent Unit LCD Screen
- 4. Parent Unit Menu Options
- 4.1 Adjust Speaker Volume
- 4.2 LCD Brightness
- 4.3 Set Alarm Time on the Parent Unit
- 4.3.1 Set lullaby
- 4.4 Monitor the Temperature
- 4.4.1 Temperature Format
- 4.4.2 Temperature Range
- 4.4.3 Temperature Alert
- 4.5 Remove a Baby Unit from the Parent Unit
- 4.6 Set Screen Off time for the Parent Unit
- 4.7 Zoom, Pan or Tilt
- 4.8 Pair and Replace a Baby Unit
- 4.9 Multi-Camera Use
- 5. Disposal of the Device (environment)
- 6. Cleaning
- 7. Troubleshooting
- 8. General Information
- 9. Technical Specifications
22 Troubleshooting
7. Troubleshooting
Power/Link Indicator on the Parent Unit does not come on
• Check whether the Parent Unit is powered on.
• Check whether the supplied battery pack is correctly installed and that it is
charged.
• Recharge the Parent Unit by connecting it to the power supply.
Power/Link Indicator on the Baby Unit flashes
• The Baby Unit may not be paired with the Parent Unit. Refer to section 4.8 to
pair the Baby Unit.
• The Parent Unit and the Baby Unit may be out of range with each other.
Reduce the distance between the units, but not closer than 1 meter.
• The Baby Unit may be switched off. Slide the ON-OFF switch on the Baby
Unit to the ON position.
icon on the Parent Unit flashes
• Battery pack in the Parent Unit is running low. Connect the Parent Unit to the
electrical outlet with the supplied power adapter for recharging.
The Parent Unit beeps
• The Parent Unit may have lost connection with the Baby Unit. Reduce the
distance between the Parent Unit and the Baby Unit, but not closer than 1
meter.
• The Baby Unit may be switched off. Slide the ON-OFF switch on the Baby
Unit to the ON position.
• Battery pack in the Parent Unit is running low. Connect the Parent Unit to the
electrical outlet with the supplied power adapter for recharging.
• The Alarm is sounding. Press any button to reset the alarm, and turn it off
from the menu if not required.
• The Temperature Alert is sounding. Check the temperature, and adjust the
alert limits, if necessary, or turn it off from the menu if not required.