Technical information

Chapter 2: AT+i Commands Reference
May 31, 2008 AT+i Commands Reference Manual 2-91
When issuing any of the following commands, W24 plays the role of a server.
Option Allowed Values
Baud Rate 300-115200 bps
Data Size 7 or 8 bits
Parity None | Odd | Even
Stop Bit 1
Flow Control BREAK ON | BREAK OFF | DTR ON | DTR OFF | RTS ON |
RTS OFF
Notify Line State One octet (byte). The value is a bit-level composition made up from the value table that
appears in the RFC2217 protocol document. Only bit 4 is supported, value 16, meaning
BREAK-detect error.
Notify Mode State One octet (byte). The value is a bit-level composition made up from the value table that
appears in the RFC2217 protocol document. Only the following bits are supported:
Bit Position Value Meaning
5 32 Data-Set-Ready Signal
State
4 16 Clear-To-Send Signal
State
1 2 Delta Data-Set-Ready
0 1 Delta Clear-To-Send